EasyPatterns® Siser Heat Transfer Vinyl

Regular price $6.00

Shipping calculated at checkout.
EasyPatterns® Cutter Settings
Cricut:   Blade: Standard   Setting: Iron-on
Silhouette Cameo:   Blade: Standard, 3   Material: Heat Transfer, Smooth   Speed: 8   Force: 6
Brother ScanNCut:   Blade: Standard, 2   Cut Speed: 1  
 Cut Pressure: 1
Roland GX/GS-24:   Blade: 45°   Gram Force:80-90   Offset: .250   Speed: 25-50 cm/s
Graphtec:   Blade: 45°  Force: 8-9  Tool:CB09U+0  Speed: 25 cm/s
MH, SC2, LP3, and Titan1:   Blade: 45°/60°   Gram Force: 80-85   Speed: 300 mm/s    
*Blade Advancing Varies
Titan 2 & 3:  Blade: 45°/60°  Gram Force: 80-85  Speed: 300 mm/s  
*Blade Advancing Varies

 

Please Note: Due to increased heat and humidity during the summer months, we recommend allowing TTD Masks to return to indoor room temperature (below 70°F/21°C) before use for best performance. If additional cooling is needed, TTD Masks can be placed inside a fridge or freezer for 5- 10 minutes.

 

Application Settings (Home Iron)
• Cut design in positive (Don't Mirror)

• Weed Excess Material

• Mask with TTD Easy Mask or TTD High Tack Mask

• Set iron dial between Cotton and Linen

• Cover with Heat Transfer Cover Sheet or Multipurpose Paper


• Place on flat, hard surface (ironing board not recommended)


• Press iron with medium/firm pressure (do not slide iron)


• Press each section of design for 15 seconds


• If areas of design lift after application, replace cover sheet
and re-press for 10 seconds


• Peel carrier hot or cold
 
Application Settings (Heat Press)
• Cut design in positive (Don't Mirror)

• Weed Excess Material

• Mask with TTD Easy Mask or TTD High Tack Mask
• Cover with Heat Transfer Cover Sheet or Multipurpose Paper

• Preheat garment for 2-3 seconds

• Apply design at 305°F/150°C

• Use medium pressure for 10-15 seconds

• Peel carrier hot or cold